Husqvarna HD775HW Manuel De L'opérateur page 5

TO ASSEMBLE GRASS CATCHER
(See Fig. 3)
1. Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
VINYL
BINDINGS
ASSEMBLY
FRAME
HANDLE
FRAME
OPENING
FIG. 3
INSTALL STARTER ROPE (See Fig. 4)
1. Loosen T-knob.
2. Hold control bar against upper handle.
3. Slowly pull engine starter rope out until rope will slip
into loop of rope guide.
4. Tighten T-knob.
ROPE GUIDE
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see "TO CON VERT MOWER" in the Operation section of
this man u al.
5
CONTROL BAR
UPPER
HANDLE
T-KNOB
ENGINE
STARTER
ROPE
FIG. 4