J5create JUA310 Guide De L'utilisateur page 13

projector) to the VGA/DVI connector of USB Display Adapter and turn
on the display device.
7. Connect the USB 3.0 Display Adapter into an available USB port of a PC
or Notebook, After Inserting the USB 3.0 Display Adapter into an USB
port, the "Installing device driver software" message will pop up.
If the Driver software was installed successfully the following message
should appear:
If you're not going to install another USB 3.0 Display Adapter, restart your
PC. The functions of the USB 3.0 Display Adapter will be activated after
the computer restarted.
Multi USB 3.0 Display Adapter Installation
For installation of multiple USB 3.0 Display Adapters, during the "Install
Shield Wizard complete" step, select "No, I will restart my computer later."
and click Finish to continue next step below
A. Connect all external display devices (monitor/ projector) to the
VGA/DVI connector of USB 3.0 Display Adapters and switch power on.
12