Technical Data; Technical Features; Technical Label; Transport And Installation - BAT Base Plus Manuel D'utilisation Et D'entretien

Base Plus
6

Technical data

6.1 Technical features

Max. dimensions (mm) and weight (Kg)
Width (mm)
Projection (mm)
Approximate weight (kg)*
Roller tube (Ø)
Safety performance per EN13561
Wind resistance class**
Nominal test pressure p (N/m
Wind speed (Km/h)
Water traps resistance class**
Total transmittance of solar energy g
MOTOR
Type
Specifications
(*) The total weight refers to maximum size of the awning with fabric not including gear or motor.
(**) Values referred to the product fully extended.
For those configurations that are not in the table, please refer to the project drawing.
The product's dimensional tolerances comply with EN13561 provision.
For the specifications of the optional accessories, see Ch.Pt.9 "Optional",
instructions.
· The resistance to pooling water is tested with an inclination of 25%; retract the awning during rain if
the angle is less than this.
· The maximum load permitted for non-retractable parts is 800 Pa.

6.2 Technical label

The "technical label", which is on the inside cover of this manual, specifies the year in which the CE marking, the
manufacturer's data and the specific product data were applied.
7

Transport and Installation

7.1 Transport

Transport and shipping shall be borne by the reseller and/or the manufacturer, who shall transport the product
using adequate packages to protect it up until its delivery to the final customer.
Any damage to the product sustained during removal and subsequent handling and/or transport,
28
) α=1
2
**
tot
Use and maintenance manual
65 - 70
70 - 80
aaa
2 (5000 x 2600)
70
39
1
see attached label
see manual for installed motor
CE marking, approved for sun awnings
5500
3100
1 (5500 x 3100)
40
29
1
P. 29 and the corresponding
Rev.06 05/09/2019