Electrolux Refine 700 E7SI1-4WB Mode D'emploi page 10

TROUBLESHOOTING
PROBLEM
Soleplate is not heating even
though iron is turned on.
Iron does not produce steam.
Steam jet and vertical steam
jet function does not work.
Water leaks from the soleplate
during ironing.
Flakes and impurities come
out of the soleplate during
ironing.
Water leaks from the soleplate
while the iron is cooling down
or after it has been stored.
Brown streaks come out of the
soleplate while ironing and
stain the linen.
DISPOSAL
This symbol on the product indicates that this product contains a battery which shall not be disposed with
normal household waste.
This symbol on the product or on its packaging indicates that the product may not be treated as household
waste. To recycle your product, please take it to an official collection point or to an Electrolux service center
that can remove and recycle the battery and electric parts in a safe and professional way. Follow your
country's rules for the separate collection of electrical products and rechargeable batteries.
Electrolux reserves the right to change products, information and specifications without notice.
10
POSSIBLE CAUSE
Connection problem
Temperature control is in "Outdoor"
position.
Not enough water in tank.
Selected temperature is lower than
that specified to use with steam.
Steam jet function was used very
frequently within a short period.
Iron is not hot enough.
The iron is not hot enough.
You have used hard water, which has
caused scale flakes to develop in the
water tank. Clean the iron according
to Cleaning section.
The iron has been put in horizontal
position while there is still water in
the water tank.
You may have used chemical
descaling agents different from the
recommendation.
Fabric fibers have accumulated in
the holes of the soleplate and are
burning.
Fabrics might not be properly rinsed
or the garments are new and have
not been washed before ironing.
SOLUTION
Check main power supply cable, plug and
outlet.
Select higher programme like "
Fill water tank (see "Getting started", no 2).
Increase temperature to at least "
Cotton".
Put iron on horizontal position and wait
before using steam jet function.
Adjust the proper temperature to steam
ironing (up to "
Cotton"). Put iron in
vertical position and wait until temperature
indicator light turns off.
Select the Cotton setting ("
maximum) suitable for steam ironing.
Put the iron on its heel and wait until the
headlight is on before you start ironing.
Press and hold the steam button for about
one minute to get steam. Then hold one
more minute in order to clean the steam
generating system. Before starting ironing,
please test your iron on an old towel to
ensure that no residues inside the iron are
transferred to your garments.
Empty the water tank.
To prevent this from happening, it is
recommended to exchange the Soft Water
Activator according to the indications.
Clean the soleplate with a damp soft cloth.
Please rinse the fabrics properly before
ironing.
www.electrolux.com
Cotton".
Cotton" to