Maintenance; Transport And Storage - jcb 18BLRH Instructions D'utilisation

Maintenance

WARNING!
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning
and maintenance – risk of electric shock and
accidental start.
Wipe the tool with a dry or damp cloth. Do
m
not use a wet cloth. Do not use detergent
that contains solvent or corrosive, abrasive
additives – risk of damaging the surface.
Keep the ventilation openings open – risk of
m
overheating.
Clear the tool vents and the accessory
m
mount of dust and dirt after each use. Do
not clean ventilation holes by inserting sharp
objects in them, such as screwdrivers and
other similar objects.
Stubborn contamination in areas hard to
m
access can be removed with compressed air
(max 3. bar).
Regularly check all fasteners, screws and
m
bolts to make sure that they are tight.
Tighten any loose screws immediately –
serious injury could occur.

Transport and Storage

If the tool shall remain unused for any
m
length of time, it should be stored in the
original packaging.
Store the tool in a dry, frost-free, well
m
ventilated place and out of the reach of
children.
Always Switch off the tool and disconnect it
m
from the power supply (remove the battery/
unplug the power cord) before transport.
16
Always carry the tool using the purpose-
m
designed handle.
Always carry the tool using the purpose-
m
designed handle.
Ensure that the tool is not at risk of tipping
m
over or exposed to vibration and shocks
during transport, especially if the tool will be
transported by car or other vehicle.
NOTE
Operating temperature: 0~40 °C
Storage temperature: -20~60 °C
Instruction & User Manual
JCB-18BLRH