Attaching The Side Handle; Setting The Depth Stop; Replacing Bits; Power Switch - jcb 18BLRH Instructions D'utilisation

Attaching the Side Handle

Push the side handle over the drill chuck and
m
screw into place.
The side handle can be fitted to suit both
m
right-handed and left-handed users.

Setting The Depth Stop

Loosen the fixing securing the depth stop.
m
Adjust the depth stop to the required offset.
m
Tighten the fixing, ensuring the depth stop is
m
securely fastened in place.

Replacing Bits

WARNING!
Tool accessories can be very sharp and can
become very hot during use - risk of
personal injury.
NOTE
The device is equipped with a SDS- plus
attachment system.
Place the tool on a stable surface, for
m
example a work bench.
Clean tools and grease with a thin layer of
m
machine grease before fitting.
Pull back fastening sleeve and hold.
m
Push and rotate the dust-free tool into the
m
tool holder as far as it will go. The tool will
lock automatically.
Check that the tool accessory is properly
m
positioned & locked into the tool holder.
14
NOTE
Check that the accessory is straight, centred
and not askew. If the accessory is not
properly positioned it could fly out when
starting the tool.

Power Switch

Press the power switch to start the tool.
m
The tool has variable speed, and a lock button
for constant use.

Variable Speed

Press the power switch to increase the
m
speed.
Release it a little to reduce the speed.
m
Release the power switch to stop the tool.
m

Rotation Selector

WARNING!
Only use the direction selector when the
tool is stopped and the chuck is not rotating.
Otherwise the tool can be damaged.
Use the rotation selector to switch between
m
clockwise rotation and anticlockwise
rotation.
Press the rotation direction switch to the left
m
for rotation in a clockwise direction.
Press the rotation direction switch to
m
the right for rotation in an anticlockwise
direction.
Instruction & User Manual
JCB-18BLRH