Husqvarna TS142L Manuel D'utilisation page 16

To move forward and rearward
The direction and speed of movement is controlled
by the motion control lever.
1. Start the engine.
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 16 .
3. To start movement, slowly move the motion
control lever (A) forward (B) or rearward (C).
D
4. Move the motion control lever more forward or
rearward to increase the speed.
5. Put the motion control lever in the neutral
position (D) when you park and stop the product.
To engage and disengage the
parking brake
1. To engage the parking brake, push down the
brake pedal (A) fully to the lowest position.
A
2. With the brake pedal pushed down, pull up the
parking brake lever (B).
3. Release the brake pedal.
4. Release the parking brake lever.
Note:
Make sure that the parking brake holds
the product safely.
5. To release the parking brake, push down the
brake pedal.
16
To
C A
B
B
To stop the product
WARNING:
product, engage the parking brake and
remove the ignition key before you go
away from the product.
CAUTION:
the warm engine can cause burn
damage to the grass. To prevent burn
damage to the grass, always stop the
engine when you stop the product on
grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Put the motion control lever in the neutral
To move forward and rearward
position. Refer to
on page 16 .
3. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 17 .
4. Put the throttle control in the slow position and let
the engine operate at idle speed for some
minutes.
5. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 15 .
6. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
To use the throttle control
The throttle control adjusts the engine speed and the
speed of the blades in the cutting deck.
Always stop the
The exhaust gas from
A
To engage
1707 - 001 - 10.09.2021