Delta 50-871 Manuel D'utilisation page 7

MOUNTINg THE AIR CLEANER TO THE CEILINg OR OvERHEAd SUPPORT
This unit weighs approximately 60 pounds. When mounting overhead, be certain that the unit is
securely fastened and supported.
1. Locate the four 1" eye bolts and the four 5/16" Flange nuts supplied with the unit.
2. Use a flat blade screwdriver (not supplied) to remove the four screws (C) Fig. 5 from the top of air cleaner (D).
3. Thread one flange nut on each bolt approximately 5/16".
4. Thread the eye-bolts (F) Fig. 6 into the four holes where the screws were removed in STEP 2.
NOTE: Be certain that the flange nuts are tightened against the surface of the air cleaner.
NOTE: When suspending the air cleaner from the ceiling or other overhead support, use steel s-hooks that are a
minimum of 5/16".
NOTE: Thread all lag hooks at least 1-1/2" into the supporting structural members.
Never secure the air cleaner hardware to drywall, drop ceiling tile/frame, or other non-structural members.
keep a minimum of seven feet between bottom of air cleaner and the floor surface.
do not use rope, cable, or power cord to suspend the unit from the ceiling. Use chain rated
for a minimum of a 150 lb. working load.
IMPORTANT: When determining a location to mount the unit, the air cleaner will operate more efficiently when the air
flow is unrestricted. Do not locate the unit in a corner or near any heating or cooling vents.
ON/OFF SWITCH
The Air Cleaner is equipped with an in-line rocker
switch (M) Fig.7, located on the power cord (N). To
start or stop the motor, press downward on the rocker
switch, according to the markings on the side. When
you are finished with the air cleaner, turn the switch off
rather than unplug the unit.
NOTE: The ON-OFF Switch must be turned "ON"
before using the remote control feature.
FIg. 5
7
FIg. 6
FIg. 7