Wagan Tech 9530 Guide D'utilisation page 5

Heated shiatsu massage belt
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION
s To reduce the risk of burning, fire, electric shock, or physical injury, please follow the
precautions below�
Do not spill liquid on any part of the unit. Do not use the unit in the bathroom or other damp
and humid places. This may cause electric shock or cause the unit to malfunction.
Do not unplug the unit when it is still operating. Power off the unit before unplugging.
Always unplug the unit when it is not in use and when there is a power outage.
Never operate the unit with a damaged power cord or plug. Do not attempt to repair the
power cord if it is damaged. Please contact us for assistance.
The device has an overheat protection system. If device fails to start, please allow 15-30
minutes for it to cool down before restarting.
Keep the unit and power cord away from heat sources, including electric blankets.
To avoid electric shock or injury, do not attempt to open or disassemble any part of the unit.
Do not allow children to play with the unit.
Use this appliance only for its intended use as described in this manual.
OPERATION
1. Connect the adaptor output to the socket of the massage device.
2. Turn on the massager and select your desired settings. (See further instructions in the
controller diagram.)
3. The massager will switch off automatically after 15 minutes. Please rest the unit for 15
minutes before using it again.
Controller
Use in Car
For passenger use only. Driver should not use this device!
Do not use in cars or automobiles when the ambient cabin temperature exceeds 104º F.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
Power
(on/off)
©2015 Wagan Corporation. All Rights Reserved.
Heat
(on/off)
Direction
4

Publicité

Table des Matières
loading

Table des Matières