Routine Maintenance - Kruger KGM15020C Manuel D'utilisation Et D'entretien

The following operations must be done in order to avoid damage to the
mechanical components subjected to bigger amount of work, and so as to
keep your washer performance efficient.
1) Important: when the machine is new, the pump/motor assembly must be run
in for a short period. This running in period entails not using the machine
for more than an hour and then waiting for an hour for it to cool. Repeat
this procedure 4 or 5 times.
2) Periodically check the oil level, which should always be higher than the
notch on the dipstick. At the beginning, oil must be changed after 50 hours
of running; subsequently, every 500 hours. We suggest using SAE 20/40
grade oil.
3) Do not leave the machine exposed to very low temperatures. Ice can damage
the pump and seriously compromise other circuits. Empty the circuits if the
machine is parked for a long time where the temperature is below freezing
point.
Make the pump run for a few minutes putting an antifreeze liquid through
the water suction pipe (A).
Vice versa, if the temperature is too high the motor will overheat when the
machine is working.
4) Do not suck corrosive liquids (paint, acid, solvent, oil or very dense liquids)
as these can permanently damage the pump.
After you use detergents or other similar liquids, always suck clean water to
rinse the machine out thoroughly and prevent the formation of scale.
5) At least once a month, check and clean the water filter of the pressure
cleaner (B).

ROUTINE MAINTENANCE

A
B
31
KGM15020C-KGM20020C