Dometic WAECO PerfectView CAM50 Notice De Montage Et D'utilisation page 32

_CAM50.book Seite 32 Montag, 7. Mai 2012 3:12 15
Mounting the camera
If you want to screw on the camera with self-tapping screws
(fig. b, page 5)
NOTICE! Risk of damage!
A
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the 3 x 10 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (fig. c, page 5)
NOTICE! Risk of damage!
A
Ensure that that nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 3.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M3 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(fig. d, page 5)
NOTE
I
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 16 mm diameter.
NOTICE! Risk of damage!
A
Ensure that there is sufficient space on the other side for the drill
head to come out
32
PerfectView CAM50
EN