Dometic WAECO PerfectView CAM50 Notice De Montage Et D'utilisation page 31

_CAM50.book Seite 31 Montag, 7. Mai 2012 3:12 15
PerfectView CAM50
Observe the following installation instructions:
 To provide a suitable viewing angle, the camera must be attached at
a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting
the camera.
 Ensure that the installation location of the camera is sufficiently firm
(e.g. to prevent the camera from being knocked down by branches that
may brush over the roof of the vehicle).
 Mount the camera bracket horizontally and in the middle of the rear of the
vehicle (fig. 0, page 5).
 The most secure type of attachment is with screws fitted through the
body. Please observe the following instructions:
– There must be sufficient space for the mounting procedure behind the
chosen installation location.
– Suitable measures must be taken to prevent water penetrating through
any holes made (e.g. by using screws and sealant and/or spraying the
outer attachment parts with a sealant).
– The location on the body where you wish to attach the camera must
be rigid enough to allow the camera to be tightly fastened.
 Check beforehand that there is sufficient room for the drill head to come
out on the other side (fig. 2, page 3).
 If you are not sure about the location you have chosen, consult the vehicle
manufacturer or dealer.
NOTE
I
We recommend greasing the threads of the bolts to prevent
corrosion.
When mounting the camera, proceed as follows:
➤ Hold the camera on the chosen location and mark at least two different
points for the drill holes (fig. a, page 5).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
EN
Mounting the camera
31