Installation And Connection - Bartscher 850001 Mode D'emploi

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
If possible, mount the dryer directly between the basin and the exit so the user does
not have to walk too far.
•
Mount the unit on the wall at least 1300mm from the
floor.
•
Drill 4 holes in the wall in order to hang the device on the
mounting.
•
The distance between the holes is 236 mm
horizontally and 200 mm vertically (see diagram).
Insert the pegs and screws delivered with the dryer
and hang dryer on them
•
Hang the device in such a way that it is easily reachable.
•
Do not hang the unit near open flame, electric or portale heaters and keep away
from heat sources.
•
Make sure that the nozzles of the device are not covered or blocked with other
objects.
•
Hang the unit in such a way that the electrical plug is easily obtainable.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
- 18 -
Floor