HQ EL-EPM02HQ Mode D'emploi page 3

The data base:
Press FUNC button the data displays as follows:
→ →
VOLTvac AMP
→
TOTAL ON TIME PRICE1
1) The meter will display current clock and line voltage, frequency, if plug in socket
after insert battery without any operation
2) Press FUNC button once and release, the meter will display current clock and line
current, power factor
3) Press FUNC button once again and release, the meter will display current clock
and real power, power factor
4) Press FUNC button once again and release, the meter will display max. line
power and the appear time of max. line power, power factor. Press and hold
FUNC button for 5 seconds will clear max. line power display during this state
5) Press FUNC button once again and release, the meter will display current clock
and accumulative power factor
6) Press FUNC button once again and release, the meter will display total on time
and total electrical charge
7) Press FUNC button once again and release, the meter will display total on time of
price 1 and total electrical charge of price 1
8) Press FUNC button once again and release, the meter will display total on time of
price 2 and total electric charge of price 2
9) Press FUNC button once again and release, the meter will come back to display
current time and line voltage. Press and hold FUNC button for 5 seconds to clear
accumulative total electric quantity and total electric charge during display state
of total electric charge or total electric charge of price 1 or total electric charge of
price 2
→
11) LCD display when total electric quantity, total electric charge overflow, the
OVER will flash at the same time
Setting current clock:
1) Press FUNC button until the CLOCK displays in LCD
2) Press SET button once time, the WEEK DAY will flash at the same time, the clock
change to SET mode, you can set the current clock
3) Press UP button to set the WEEK DAY
4) Press SET button once time again and release, the HOUR will flash the WEEK
DAY will stop flashing and keep display
5) Press UP button to set the HOUR
6) Press SET button once time again and release, the MINUTE will flash, the HOUR
will stop flashing and keep display
7) Press UP button to set the MINUTE
8) Press SET button once time again and release, the time come back to CLOCK
display mode
9) Press UP button during the CLOCK display state, change 12-24 hour mode.
To reset incorrect time, repeat all above steps. After finish setting, plug the meter
into a regular 231/241V power outlet, plug in an appliance that you want to use
and turn the mains power on. Now the meter begins to measure the consumption
of the appliance and detect the equipment that uses too much electricity at once
→ →
WATT MAX WATT
→
PRICE2
3
→
KWh TOTAL PRICE;