RCBS Lube-A-Matic Heater 80006 Instructions D'utilisation page 4

• Keep your hands and fingers away from "danger" spots and pinch-points
where they might be injured.
• Keep all reloading equipment and components out of reach of children.
• Keep all packing material out of reach of children.
• This device is not intended for use by individuals with restricted physical,
sensory or mental capacities or those with a lack of experience and/or
knowledge, including children, unless they are supervised by an individual
who is responsible for their safety or have received training in operating the
device.
• Stay alert. Reload only when you can give your undivided attention. Do not
reload when tired, ill, rushed or under the influence of drugs or alcohol.
Because RCBS has no control over the choice, assembly or use of components or
®
other reloading equipment, RCBS assumes no liability, expressed or implied, for the
use of ammunition reloaded with this product.
WARNING! DO NOT SMOKE WHILE RELOADING.
HEATER OPERATIONAL WARNINGS
• Do not use the heater in wet or damp areas.
• Do not attempt to remove the heating element from the heater plate.
• Do not pull or yank on the electrical cord, and keep the cord away from
sharp edges.
• Keep children away from the heater.
• Do not operate the heater if the electrical cord is damaged in any way.
Return the unit for repair or replacement.
• Do not allow the electrical cord to rest on the heater plate or come in
contact with any other heat source.
• Do not drill, cut or modify the heater plate in any way.
• Do not operate the unit without lube/sizer attached. This may cause the
unit to overheat.
ABOUT THE RCBS® LUBE-A-MATIC® (LAM) HEATER
Bullet casting is easier with the RCBS® Lube-A-Matic® (LAM) Heater. The LAM Heater
helps keep bullet lube flowing, ensuring proper sizing and lubricating in less time.
Hard lubes may be used without the risk of damaging your sizer by warming them
to a temperature that allows the lube to flow easily through your die lube holes and
into the bullet grooves. It mounts to RCBS® accessory base plates, and is compatible
with RCBS® Lube-A-Matic® Sizers, as well as other lead bullet sizers (Lyman, Saeco
and Star).
4