Energy Control; Preparation - Broncolor RFS 2.2 Mode D'emploi

5.

ENERGY CONTROL

5.1

Preparation

Longer press on key " ST ": Turn the scrolling wheel as appropriate to change
the studio channel up or down. Confirm the selection by a short press on key
" ST ".
The RFS 2.2 transceiver allows you to change the energy setting of all RFS 2
flash units that are set to the same studio address (in the " ST " menu) and to
change the output of individual lamp channels (in the " LP " menu). The output
can be adjusted in 1/10 and full f-stop steps.
5.2 Menu "ST"
Short press on key " ST ": Turn the scrolling wheel upwards or downwards to
increase or reduce the total energy of all units. This takes place in 1/10 f-stop
steps. Confirm the selection by a short press on key " ST ".
5.3 Menu "LP"
Short press on key " LP ": Turn the scrolling wheel upwards or downwards to
increase or reduce the energy of selected lamps. This takes place in 1/10 f-
stop steps. Confirm the selection by a short press on key " LP ".
11