Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual DataDesk 80/90
Installation of your mobile printer
Installation of your mobile printer
Open your DataDesk 80/90.
1)
Remove the flap lid from the bottom part of the case, which functions as your Notebook workspace.
2)
Place the printer power supply in the front pocket of the bottom part of the case (Fig.2, pocket No. 6).
3)
Now connect the Euro 8 plug with the 220 V socket of the power supply (Fig.2, in pocket No. 6).
Secure the printer power supply with the two Velcro straps!
4)
Route the printer power cable through the designated groove (under the flap lid) and sideways past
the printer (Fig. 3).
Pay attention to a clean cable routing to prevent damaging the printer cable (e.g. by
pinching it off)!
5)
The power supply outlet plug is now connected to the printer.
Installation of your Notebook
Installation of your Notebook
1)
Place the Notebook power supply in the rear pocket of the bottom part of
the case.
2)
Now connect the 220 V plug with the Notebook's power supply.
3)
Route the low voltage power supply outlet cable beneath the flap lid
through the designated groove, so that the cable can not be damaged
when the lid is closed!
4)
The power supply outlet plug is now connected with the Notebook.
Now you have two options of fastening your Notebook:
1)
Either you use the four synthetic corners which are provided within the
scope of supply and fasten them by using the eight self-adhesive
3M Velcro pads (Fig. 4) or
2)
you use the self-adhesive 3M Velcro pads and adhere these in pairs directly
onto the case lid and the bottom side of your Notebook (Fig. 5).
During transport always fasten your Notebook with the Velcro strap (transport protection)
on the upper side of the flap lid (Fig. 6)
Fig. 3
Fig. 4
Fig. 5
Fig. 6
7
Publicité
Chapitres
Table des Matières
