User Manual DataDesk 80/90
Dear Customer,
We would like to thank you that you bought a DICOTA product. Before you use your DataDesk 80/90 for the first time please read the following
user manual thoroughly. The DataDesk 80/90 is suitable for the currently available printer models Canon i80/iP90. Please consult your local
dealer or the product detective at www.dicota.com to find out which Notebooks are suitable.
Table of contents
Table of contents
General information
General information - DataDesk 80/90
General information - DataDesk 80/90
Work enviroment
Please make sure that your DataDesk 80/90 is always operated on a steady, non-skid surface. Especially avoid working surfaces in dusty or damp environments!
→ When opening your DataDesk 80/90 attaché case, please make sure that the case shell with the case handle is upside!
→ If you would like to use your DataDesk 80/90 without the upper case shell, you can remove it as follows: Open the attaché case at an angle of approx. 60° - 70°.
At this angle you feel a slight resistance and you can detach the case lid by pulling it horizontally to the right.
→ Avoid the use of your DataDesk 80/90 near extreme heat sources (e.g. heaters). Protect your DataDesk 80/90 from direct sun irradiation!
→ For exact information regarding the temperature of the work environment, please refer to the user's guide of your Notebook or printer manufacturer.
→ The equipment should only be operated when the case is opened.
→ The case should not be immediately closed after the equipment has been used for a long period of time, so as to ensure a cooling-off period!
Operating voltage / recharging procedure
→
Please keep in mind that the line cord is to be attached to the case first, and then connected to the power source, when connecting with the power supply system!
→ The DataDesk 80/90 should always be opened during the recharging procedure of the equipment!
5
5
5
6
6
6
6
7
7
8
5