PALSON Panther Mode D'emploi page 5

GB E
Our products are designed to meet the highest standards of quality, functionality and design. We hope you
enjoy your new PALSON PANTHER hairdryer.
SAFETY PRECAUTIONS
1. Avoid contact with the hot surfaces of the appliance.
2. Make sure the air inlet and outlet are not blocked while the hairdryer in use.
3. Do not coil the cord around the hairdryer.
4. The hairdryer should be cooled down before storing.
5. Do not use the hairdryer while in the bath, the shower or near the washbasin or other receptacle
containing water or liquids.
6. Do not place the hairdryer where it can come into contact with water or other liquids.
7. When using the hairdryer in a bathroom, it must be disconnected after use as proximity to water could
be hazardous even when the dryer is stopped.
8. Hazards also exist even when the hairdryer is switched off, therefore, disconnect the plug from the
mains supply after use by pulling the plug and not the cord.
9. Hazards and safety measures should be made known to children. Checking an appliance has been
turned off is necessary when any appliance is used by or near children or any person with a disability.
Keep out of reach of children.
10. Do not attempt to obstruct any of the hairdryer's air inlets or outlets.
11. Do not use accessories other than the manufacturer's.
12. To ensure greater protection it is advisable to install a residual current device (RCD, max. 30watt) in
the electrical supply in the bathroom. Ask your technician to advise accordingly.
13. Unless supervised by an adult, children or other persons whose physical, sensory or mental condition
prevents them from using the appliance safely are not permitted to use this product. Children should
be supervised to ensure they do not play with said product.
14. If the power cord is damaged, it must be replaced by the manufacturer, by an authorised service
agent or by a qualified technician, in order to prevent hazards.
IONIC TECHNOLOGY: The new Palson hairdrying system using ionized air, allows the hair to dry
surprisingly quickly.
The hairdryer seemingly operates like a conventional hairdryer, but its interior is fitted with a complex
electronic system that ionizes the air before being expelled.
Ionization causes the splitting of the water particles into micro-particles, thereby facilitating the fast
and natural absorption of water, leaving the hair with an exceptional texture and sheen, in addition to
eliminating static electricity.
CERAMIC TECHNOLOGY: It is known that ceramic technology emits reflexive ions, inhibiting the growth
of bacteria, renewing and improving the vitality of your hair and distributes heat evenly. The result is soft,
silky and shiny hair.
TOURMALINE TECHNOLOGY: Tourmaline technology hairdryers are made from 100% crushed
Tourmaline mineral. Tourmaline is a semiprecious stone and is the world's finest ionic and infrared
generator. Ions and infrared combine to give the best possible results. Tourmaline constantly and naturally
delivers negative ions and infrared heat providing great benefits for your hair.
8
NOTE ON USING FOR THE FIRST TIME
Your new hairdryer has been manufactured with a protective layer around the coils of the internal heat
resistance. When you switch it on for the first time you will probably notice that it smells of burning and
it smokes a little. This poses no hazard to the user nor is it a defect in your hairdryer. Keep the hairdryer
switched on until the smoke evaporates.
SHORT CIRCUIT DUE TO OVERHEATING
This appliance is equipped with a thermostat which will cut out the hairdryer should it overheat. In the
event of the appliance cutting out while in use, set the switch to the off (O) position and allow to cool
down. Once the appliance has cooled down, the thermostat restarts automatically and you can resume
drying. During use, do not obstruct the air inlets or outlets, as this may cause the appliance to overheat
and subsequently cut out. Periodic cleaning of the back cover is necessary in order to maintain hairdryer
performance and to prevent it from overheating. While using the hairdryer the area around the air outlet
becomes hot; avoid touching it and any accessory attached to it.
DIRECTIONS
1. Uncoil the power cord completely.
2. If required, fit a nozzle or the diffuser to the hairdryer.
3. Adjust the temperature and speed.
4. Cold air button: by pressing this button the hot air flow cuts off. The hairdryer only expels air at room
temperature. Use this setting to set your hairstyle.
CLEANING AND CARE
1. The appliance must be unplugged before cleaning.
2. Allow the appliance to cool down before cleaning.
3. Regularly clean the air inlet cover.
4. Clean the hairdryer with a soft, dry cloth.
5. Do not use abrasive detergents, solvents or cleaning products. Never immerse the appliance in water
when cleaning.
6. Dry any moisture from the hairdryer before use.
7. Never attempt to repair or replace appliance parts yourself.
STORAGE
Unplug the appliance and leave to cool down before storing in its box or in a dry place. Never store the
hairdryer while it is hot or still plugged in. Never coil the cord around the appliance.
Never hang the unit by the cord. Store the cord loosely coiled. Do not exert pressure on the cord at the point
where it is connected to the unit, as it could cause the cord to break or to become damaged.
ENVIRONMENTAL PROTECTION
Discarded electrical products must not be thrown away with household garbage. This device must be
brought to its local recycling center for safe processing.
Thank you for choosing one of our products.
9