Metabo HPT UC 18YSL3 Instructions De Sécurité Et Mode D'emploi page 8

English
APPLICATIONS
For charging the metabo HPT batteries types BSL14 series, BSL18 series, and MV series.
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING:
1. Connect the battery charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle, the charge indicator lamp will
blink in red. (At 1-second intervals).
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as
shown in Fig. 2.
8
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
Do not use the electrical cord if damaged.
Have it repaired immediately.
Charge
indicator lamp
Battery
Guide rail
Fig. 2