Assembly And Operation; Applications; Prior To Operation - Hitachi SV13YA Instructions De Sécurité Et Mode D'emploi

ASSEMBLY AND OPERATION

APPLICATIONS

Roughing or finishing of woodwork and metal surfaces.
Preliminary sanding of woodwork and metal surfaces before painting.
Paint removal.
Rust removal.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specified on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle
while the switch is in the ON position, the power tool will start operating immediately
and can cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as short as
practicable.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact
a licensed electrician to make appropriate repairs.
If such a faulty receptacle is used, it may cause overheating, resulting in a serious
hazard.
5. Check your working environment
Ensure the following before operation;
No flammable gas, liquid, or object at worksite.
Sanding thin steel sheet may cause a high booming sound.
In this case, place a rubber mat under the workpiece.
Take appropriate noise preventive measures to prevent adverse affects on the
environment by electrical noise.
Clear the area of children or unauthorized personnel.
WARNING:
Damaged cord must be replaced or repaired.
English
9