Installation; Positioning / Electrical Connection - Kuppersbusch IKE 160-2T Instructions De Montage Et D'emploi

Masquer les pouces Voir aussi pour IKE 160-2T:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation

Take utmost care when handling your
appliance so as not to cause any damages
to the cooling unit with consequent possible fluid
leakages.
During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
Important: if the supply cord is damaged, it must be
replaced by a special cord or assembly available
from the manufacturer or its service agent.
Positioning
Unpack the cabinet and check that it is in good
condition and free of any transport damage.
The appliance must not be located close to
radiators or gas cookers.
Avoid prolonged exposure of the appliance to direct
sunlight.
For safety reasons, minimum ventilation must be as
shown in Fig.
Attention: keep ventilation openings clear of
obstruction.
It is necessary that the niche is provided with a
conduct of venti-lation having the following
dimensions:
Depth: 50 mm
Width: 540 mm
The climate classification can be found on the rating
plate, which is located inside the cabinet on the left
hand wall.
The following table shows which ambient temperature
is correct for each climate classification:
Climate
classification
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
Important
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed.
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C.
Directives:
- 87/308 EEC of 2/6/87 relative to radio
interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent modifications.
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility
Directive)
modifications.
GB
for an ambient
temperature of
+10 to +32 °C
+16 to +32 °C
+16 to +38 °C
+16 to +43 °C
and
subsequent
23

Publicité

Table des Matières
loading

Table des Matières