Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
MIXING
For mixing thin-set, grout, mortar and paint.
CAUTION: Use extreme caution to avoid getting water in the mixer, and around your working
area. Add water to the mix container away from the mixer, electrical supply cords, and your work area.
Wear rubber boots and gloves when mixing material containing water.
In the event water enters the Power Mixer Pro housing, DO NOT OPERATE THE MIXER UNTIL IT IS
COMPLETELY DRY! Damage to your mixer, electric shock, or severe bodily injury may occur!
a.
To keep the mixer motor running at full speed without continuously squeezing the trigger:
1. First, squeeze the trigger.
2. Then, press the trigger lock button.
3. While pressing the button, release the trigger.
The mixer is now locked into the ON position and will continue to run. To release the trigger
lock, squeeze the trigger.
b.
Secure the provided male-threaded mixing paddle in the chuck with the supplied wrench.
The supplied mixing paddle is ideal for thinset grouts and other viscous materials.
c.
If using a non-threaded mixing paddle, you must use the included
Chuck Kit. Simply attach the chuck to the M-14 chuck screw
and then attach the other end of the M-14 screw to the mixer (as
shown), using the wrench provided. Now use the chuck key to
tighten the chuck around the shaft of the mixing paddle.
d.
Use a bucket or mixing vessel at least 25% larger than the volume of material you intend to
mix. Do not fill the container to the top. For example, if you are using a five gallon bucket,
leave at least four inches at the top to minimize spills and splashing.
e.
Run the mixer at low speed using the variable speed dial until the dry material and water
are evenly distributed. Do not run the mixer at high speed if it appears to be slowed down
or labored. If the mixer begins to heat up, allow it to cool, then run at a lower speed.
f.
When finished mixing, remove the mixing paddle from the mixer. Wipe any water, mud or
debris from the mixer with a clean, dry cloth. Wash the mixing paddle with clean water. Do
not allow grout, mortar or paint to dry on the mixing paddle.
- 6 -
C.
Publicité
Table des Matières
