Turning The Display On/Off - VESTEL PDM-49UG02 Manuel D'utilisation

Connecting the IR Receiver
Before plugging the Display into the mains supply, connect the supplied IR receiver to the IR input on the
Display. Place the IR receiver in sight of your own remote control. Simply operate your remote control whilst
pointed at the IR receiver and it will relay the control signal to your Display.

Turning the Display On/Off

Press the Standby button on the remote or on rear left side of the Display to switch it on from standby or to
switch it into standby mode.
LED Status
Power LED not lit
Power LED lit
Power LED flashing (slow)
Power LED flashing (fast)
Joyst�ck
V+ V-
Status of the monitor
Power on
Power off (Standby mode)
Scheduler active
Power up/down and software update
English - 8 -