Publicité
Les langues disponibles
Les langues disponibles
Operation
Charging the Battery
Use the USB charging cable supplied to connect the micro USB charging jack (8)
to a suitable USB port.
During charging the indicator light (7) lights up red. After charging has ended, the
charge indicator light lights up green.
After charging has finished, disconnect the light from the charging cable.
Use
Fold out the pliers as shown in the figure on p. III. The pliers are equipped with a
wire cutter.
The bit depot (12) is located in a leg of the pliers, in which the bit holder (10) is also
and can be gripped with a fingernail and folded out. It contains four bits (2x PH2, 2x
T15).
Use the slide lock (4) to unlock and remove the knife unit with the light. The knife
unit is equipped with blade, rope cutter and saw.
To re-insert the knife unit, hook it into the tabs on the pliers and lock the knife unit
with the slide lock (4).
Using the light
Press the ON/OFF button (5), to switch on the light. Press the ON/OFF button
again to switch off the light.
Maintenance and storage
Do not use aggressive chemicals, solvents or abrasives to clean the combination
tool. If necessary, use a small amount of oil-free lubricant (e.g. silicone spray). Do
not allow liquids of any kind to enter the torch or immerse the torch in liquids of any
kind.
Store the torch in a place away from direct sunlight, dust, humidity, extreme
temperatures and vibrations and out of the reach of children.
7
Publicité
