SEVERIN TASTEFLL Mode D'emploi page 13

Smoothie-maker operation
∙ Cut the ingredients into cubes of about 15
mm and put them into the drink container
(see pic. A).
∙ For best results, the following sequence
should be observed:
1. liquids
2. fresh ingredients
3. frozen ingredients
4. yoghurt/ice-cream
∙ The container has a maximum capacity of
600 ml.
∙ Screw the blade unit clockwise onto the
drink container.
∙ Turn the container upside down and fi t it
to the motor housing in such a way that
the two triangle symbols are aligned. Now
lock the container by turning it clockwise.
∙ Insert the plug into a suitable outlet and
use the rotary control to select the desired
speed setting or the pulse function (P).
∙ Caution: Do not operate the appliance
when it is empty. Do not fi ll it with dry
items only, such as nuts, almonds etc.
∙ If some residue sticks to the drink
container's sidewalls, remove the
container, shake it and let it run through
another brief pulse cycle.
∙ Remove the plug from the wall socket
after use. Wait until the motor has come
to a complete standstill before removing
the container and unscrewing the blade
unit.
∙ Close the container with its lid.
Wind-up power cord storage
The power cord can be wound up for storage
on the underside of the unit. Unwind it
completely before operation.
Information for testing institutes:
The following recipe may be used:
Mix 400 g soaked carrots and 600 g water
for 3 minutes.
Cleaning and care
∙ Always remove the plug from the wall
socket before cleaning the appliance.
∙ To avoid the risk of electric shock, do not
clean the motor housing or the power
cord with water and do not immerse them
in water. The motor housing may be
wiped with a slightly damp, lint-free cloth.
∙ Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning.
∙ For cleaning directly after use, fi ll the
blender jug (max 700 ml) or drink
container (max 400 ml) with warm water
and a little detergent. Let the appliance
run for a short period as described in
the section Operation. Afterwards, rinse
the blender jug or drink container with its
blade unit, the lids and stopper with fresh
water. All parts must me thoroughly dried
afterwards.
∙ The drink container and lids can also be
cleaned in a dishwasher. All other parts
are not dishwasher-safe.
∙ If necessary, the sealing gasket on
the blender jug lid can be removed for
cleaning. Before the appliance is used
again, the gasket must be replaced.
∙ If required, the blade unit for the blender
jar can be detached for cleaning: fi rst
remove the collar under the jar by turning
it clockwise (see pic. B), and lift out the
blade unit (pic. C). Caution: The blades
are extremely sharp. The gasket in the
drink container cannot be removed.
Clean the blade unit with a suitable brush.
Wipe the gasket with a moist cloth. To
13