SEVERIN TASTEFLL Mode D'emploi page 12

damage results from improper use, or if
these instructions are not complied with.
Before using for the fi rst time
Before the appliance is used for the fi rst
time, the blender jug, drink container and lids
should be thoroughly cleaned as described
in the section Cleaning and care.
Switch settings
The following settings can be selected:
P The appliance remains switched on as
long as the rotary switch is held in this
position
0 The appliance is switched off
I Low power
II Maximum power
Short-term operation
The appliance is designed to process
average domestic quantities of food; it
can be operated without interruption for
a maximum of 3 minutes, after which it
should be allowed to cool down to room
temperature.
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated if the blender jug is properly locked
in position.
Before removing the blender jug, make
sure that the rotary control is in position 0.
This also applies when fi tting the blender
jug to the motor housing. If the control is
not in its off-position (0), the motor will start
immediately.
Multi-mixer operation
∙ Fit the blender jug to motor housing, with
12
its handle to the right, in such a way that
the two triangle symbols are aligned.
∙ Put the liquid ingredients into the blender
jug. The jug has a maximum capacity of
1000 ml. To avoid possible foaming or
spilling when processing foamable or thin
liquids such as milk, do not fi ll the jug over
the 700 ml mark.
∙ Replace the lid so that the spout is
completely covered.
∙ To add ingredients during operation, the
stopper in the centre of the lid can be
removed. Do not put any objects into
the blender jug while the appliance is
operating.
∙ Insert the plug into the wall outlet and use
the rotary control to select the required
power setting.
∙ Caution: Do not operate when the
blender jug is empty. Do not fi ll it with dry
items only, such as nuts, almonds etc.
∙ After using the blender, switch off and
remove the plug from the wall socket.
Wait until the motor has come to a
complete standstill before removing the
blender jug.
Using the multi-mixer to crush ice
Ice-cubes can be easily crushed in the
blender jug:
Fill the jug a quarter full with ice cubes, and
then fi t it to the motor housing, as described
in the section Multi-mixer operation. Put on
the lid with the stopper in place, and use the
pulse function (P) to operate the appliance
for about 2 seconds. Wait until the ice cubes
have collected in the bottom of the jug again
and then repeat the process, until the cubes
have been reduced to the required size.