Assembly And Operation; Applications; Prior To Operation - Metabo HPT P 20ST Mode D'emploi

English

APPLICATIONS

Planing various wooden planks and panels
Fig. 2-A (Planing)
23/64"(Max)
(9mm)
Fig. 2-D (Tapering)

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power source requirements specified on the
product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the
plug is connected to a receptacle while the switch is
in the ON position, the power tool will start operating
immediately and can cause serious injury.
3. Extension cord
When the work area is far away from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
WARNING:
Damaged cord must be replaced or
repaired.
8

ASSEMBLY AND OPERATION

Fig. 2-B (Beveling)
Fig. 2-E (Side planing of flush door)
4. Check the receptacle
If the receptacle only loosely accepts the plug, the
receptacle must be repaired. Contact a licensed
electrician to make appropriate repairs.
If such a faulty receptacle is used, it may cause
overheating, resulting in a serious hazard.
5. Confirming condition of the environment
Confirm that the work site is placed under
appropriate conditions conforming to prescribed
precautions.
6. Prepare a stable wooden workstand suitable for
planing operation. As a poorly balanced workstand
creates a hazard, ensure it is securely positioned on
firm, level ground.
7. Confirm that the cutter blades are securely tightened
The cutter blade is securely bolted at the factory,
rendering the machine immediately usable on site;
however, use a box wrench to retighten the bolts
prior to operation.
23/64"(Max)
(9mm)
Fig. 2-C (Rabbeting)
Side face cutting