Maintenance And Inspection - Metabo HPT P 20ST Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
WARNING:
Be sure to switch power OFF and disconnect the
plug from the receptacle during maintenance and
inspection.
1. Inspecting the cutter blades
Continued use of dull or damaged cutter blades will
result in reduced cutting efficiency and may cause
overloading of the motor. Sharpen or replace the
cutter blades as often as necessary.
2. Handling
CAUTION:
The front base, rear base, and cutting depth
control knob are precisely machined to obtain
specifically high precision. If these parts are
roughly handled or subjected to heavy mechanical
impact, it may cause deteriorated precision and
meduced cutting performance. These parts must
be handled with particular care.
3. Inspecting the screws
Regularly inspect all screws and ensure that they
are fully tightened. Should any of the screws be
loosened, retighten them immediately.
WARNING:
Using this planer with loosened screws is
extremely dangerous.
4. Inspecting the carbon brushes (Fig. 19)
The motor employs carbon brushes which are
consumable parts. Replace the carbon brush with a
new one when it becomes worn to its wear limit.
Always keep carbon brushes clean and ensure that
they slide freely within the brush holders.
No. of carbon brush
Wear limit
21
0.47" (12mm)
CAUTION:
Using this planer with a carbon brush which is
worn in excess of the wear limit will damage the
motor.
12
MAINTENANCE INSPECTION
0.20" (5mm)
Fig. 19
NOTE:
Use metabo HPT carbon brush No. 21 indicated in
Fig. 19.
5. Replacing carbon brushes
Disassemble the brush caps (Fig. 1) with a slotted
screwdriver. The carbon brushes can then be easily
removed.
6.
Replacing supply cord
If the replacement of the supply cord is necessary,
this has to be done by metabo HPT Authorized Service
Center in order to avoid a safety hazard. Replacing
7.
drive belt.
If the replacement of the drive belt is necessary, this
has to be done by metabo HPT Authorized Service Center
in order to avoid a safety hazard.
8. Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because of wear
from normal use. To assure that only authorized
replacement parts will be used, all service and
repairs must be performed by a metabo HPT
AUTHORIZED SERVICE CENTER, ONLY.
9. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION:
Repair, modification and inspection of metabo HPT
Power Tools must be carried out by a metabo HPT
Authorized Service Center.
This Parts List will be helpful if presented with the
tool to the metabo HPT Authorized Service Center when
requesting repair or other maintenance. In the
operation and maintenance of power tools, the
safety regulations and standards prescribed in
each country must be observed.
MODIFICATIONS:
metabo HPT Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.

Publicité

Table des Matières
loading

Table des Matières