Teckentrup carTeck 12.1 Notice De Montage Et D'utilisation page 26

26 Learning the end closing points of the door - Programming the power
1
Programming the travel path:
2
To activate the travel path adjustment:
3
Programming in the end closing positions of the doors.
Attention!
Shortly before the end closing point of the door is reached, adjust by pressing the button only very briefly
(1 press moves door approx. 2 mm).
Attention:
Only set the end closing point of the door!
Chain or belt should never hang out from
the rail at the end closing point of the door.
4
Changing the direction of motion
The direction of motion can be changed as often as desired by briefly pressing the TL button.
This makes it possible to set the end closing point of the door exactly.
Subject to technical modifications without prior notice.
Press pushbutton TL.
Remove 1 time for about 5 seconds until yellow LED lights.
Yellow LED lights constantly.
Press TS. Remove 1 time for about 1 second
until yellow LED begins to flash.
Press TS constantly until the end closing point of the
door is reached.
If you press TS briefly you can bring
the door slowly to the end closing point.
Press the TL button for 1 sec. to change the direction
1 Sec
of motion.
The TS button starts the door moving.
TP-12. 1 -07/13