Introduction; Supplied Accessories; Attaching The Stand; Symbols Used In This Manual - Emerson LC320EMX Guide D'utilisation

I
NTRODUCTION

Supplied Accessories

owner's manual
(1EMN24300)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.

Attaching the Stand

You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper
direction.
1
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by above "
holes. After the screws are removed pull the stand up toward
the rear of the unit. Be careful not to drop the stand when you
remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:
TV : Analog TV operation
• If neither symbol appears under the function heading, operation is applicable to both.
4
EN
quick start guide remote control
(1EMN24640) (NH000UD)
2
Align the 2 stand hooks with the two
hooks under the bottom of the main
unit (shown by arrow
the stand in the direction as shown
➁
by arrow
mounting holes are aligned.
Make sure not to put the AC power
cord between the stand and the
unit.
➁
➂
"screw
registration card
(1EMN24701)
batteries
(AAA x 2)
➀
), then slide
until it stops and the 4
➀
➀
DTV
: Digital TV operation
Phillips pan screw for
attaching the stand x 4
(FPH34200)
3
Drive Phillips pan screws in the 4
threaded holes at the bottom of the
stand until they are tight.
➂ ➂
screw holes screw holes screw holes