Publicité
Les langues disponibles
Les langues disponibles
SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining Nut
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft (A)
aligning the pump handle hole and shaft hole. Slide the bolt (B) through
the aligned hole as shown in figure 1 thru 4. Tighten nut (D) to bolt.
There are holes in the pump handle to allow for either left(fig.4) or right
(fig.5) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt
INSTALLING THE SHOULDER STRAP
The top of the shoulder straps are attached to the tank.
Attach the lower end of the straps by clipping the strap hooks to the
metal frame between where the frame exits the tank and curves around.
WAND CLIP
The wand can be attached
to the metal frame using the
wand clips.
O-ring
Wand
Figure 2
Line up holes
Figure 5
Left Hand
Wand Clip
3E
Shut-off
Valve
A. Pump Shaft
D. Nut
B. Bolt
C. Pump Handle
Figure 3
Slide bolt through holes
Figure 6
Right Hand
Publicité
