English Description; Introduction; Note; Installation - Cristec SOLO 12V 200W Manuel D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Introduction

The sine-wave inverters of the SOLO series have been designed to meet industrial and domestic needs. They fulfil the

highest requirements of comfort, safety and reliability.

Any device designed for the public electrical network of 230V 50 Hz can be connected to them (up to the nominal

power of the inverter).

The SOLO series is the perfect source of tension in any place where the public network is not available.

This document is an essential part of the inverter and must always be carried with it and be at the disposition of anyone

working on the installation.

Should you have any doubt or question, do not hesitate to contact your specialist salesperson who will give you the best

advice.

Note

A deficient assembly could result in damage to the device, cause function failures or potential damage to the users.

The working device generates a high tension which might be fatal in case of contact. So, any manipulation of the

inverter must be carried out with utmost care.

THE OWNER MUST NOT MANIPULATE ANY PIECE INSIDE THE INVERTER.

Opening the inverter or using it incorrectly will result in the immediate loss of the warranty.

No current or tension generating devices (public grid, generator,...) may be connected to the outlet of the inverter

because this could result in its destruction.

The SOLO inverter can be used with any kind of battery type: lead-sealed, open batteries, gel, AGM, spiral-lead, etc...

As for the usage of batteries, follow the manufacturer's instructions.

Installation

The SOLO sine-wave inverter is an electronic device, for which some caution must be taken when installing it:

Place where the inverter is to be installed :

 Out of reach of unauthorised persons, especially children.

 In a dry place (max. 95% humidity), and in any case with no condensation.

 Not directly on top of the batteries.

 Ventilation must be free, and a space of 10 cm. on each side is needed for good evacuation of the internal heat.

Fitting the inverter

The inverter is fitted by screws (max. 4mm for SOLO 200/300/400/500/800/1000W or max. 8mm for SOLO 2000W)

using the four holes provided. The fitting screws are not supplied with the inverter.

It may be fit into any position.

SOLO1DEH