Transportation - STERWINS 20 VHT2-50.1 Notice De Montage, Utilisation Et Entretien

NOTE : While trimming, the cutting device may be blocked. So
the product will turn off automatically due to over current.
Therefore release the on/off switch and then start again to go
on with trimming.
After use : Illustration 5.4
Clean the power tool (refer to chapter maintenance) and attach the blade cover 8.
Removing and charging the battery : Illustration 6.1 and battery instruction manual
1. Press the lock button on the top center of the battery to slide it out of the product.
2. Place the battery pack into the charger by sliding it into a locked position until it clicks
3. When the green light is fl ashing, the battery is charging. If the green light is no longer fl ashing, the
battery is fully charged.

5. TRANSPORTATION

Transporting the machine or battery may require that you meet certain requirements specifi c to your
country. Please make sure to respect them by contacting the authorities of your country, in order to
respect them all. Ensure temperature during transportation will never be out of temperature range given
on chapter storage
5.1 TRANSPORT THE MACHINE
Illustration 5.1
Switch the product off and remove the battery pack.
Always carry the product by its handle. Protect the product from any heavy impact or strong vibrations
which may occur during transportation in vehicles. Secure the product to prevent it from slipping or
falling over. Do not expose the product to sunlight.
5.2 TRANSPORT THE LITHIUM BATTERIES
Please refer to the battery instruction manual for further details.
6. WINTERING
Illustration 6.1
Plug out the battery from the power tool.
Before long storage please ensure the battery charge fi t to instructions provided on battery instruction
manual. Follow all instructions given on chapter storage below. We recommend using the original
package for storage or covering the product with a suitable cloth or enclosure to protect it against dust.
7. STORAGE
Only store the machine and the battery in a clean, dry, ventilated place with a temperature range of 4°C
to 24°C. Cover it in order to provide added protection. We recommend using the original package for
storage or covering the product with a suitable cloth or enclosure to protect it against dust. Be sure to
secure the unit while transporting
7.1 STORE THE MACHINE
Illustration 6.1
Plug out the battery from the power tool. Examine the unit thoroughly for worn, loose or damaged parts.
Clean the unit before storing. Do not expose the product to sunlight. Make sure the product is always
protected from cold and humidity.
253
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN