System Settings; Illumination Settings - Pioneer FH-X820BS Mode D'emploi

*3 Not available when [FUL] is selected in [REAR-SP] in the INITIAL settings (page 7).
*4 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 7).
*5 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
CLOCK SET
12H/24H
[12H], [24H]
INFO DISPLAY
AUX
[ON], [OFF]
BT AUDIO
[ON], [OFF]
BT MEM CLEAR
[YES], [CANCEL]
BT VERSION
APP CONN. SET*
[WIRED], [BLUETOOTH]
* Not available when [PANDORA] or [APP] is selected as the source.
Description
Set the clock (page 6).
Select the time notation.
Display the item on the sub information display.
Select from "SPEANA, " "LEVEL METER, " "SOURCE,"
"CLOCK, " and "OFF. "
Set to [ON] when using an auxiliary device
connected to the unit.
Set the Bluetooth signal on/off.
Clear the Bluetooth device data (device list, PIN
code, call history, phone book, preset phone
numbers) stored in the unit.
[CLEARED] appears when data is successfully
deleted.
Displays the system version of the unit and the
Bluetooth module.
Select the appropriate connection method
according to your device.

ILLUMINATION settings

Menu Item
COLOR
[KEY COLOR], [DISP COLOR],
[BOTH COLOR]
DIM SETTING
[SYNC ILLUMI], [SYNC CLOCK],
[MANUAL]
BRIGHTNESS
[1] to [10]
PHONE COLOR (Not available for FH-X520UI)
[FLASHING]
[FLASH FX1] to [FLASH FX6]
[OFF]
Description
Select color for the keys/display of the unit from
12 preset colors, [SCAN] or [CUSTOM]*.
• [SCAN]: Cycle through a variety of colors
automatically.
• [CUSTOM]*:
1 Press and hold the M.C. dial until the color
setting display appears.
2 Set the primary color (R (red)/G (green)/B
(blue)) and brightness level ([0] to [60]).
You cannot select a level below 10 for all three
of R (red), G (green), B (blue) at the same time.
You can also customize the preset colors. Select
one of the preset colors, then press and hold the
M.C. dial until the color setting display appears.
* The CUSTOM setting is only available for [KEY
COLOR] and [DISP COLOR].
Change the display brightness.
Change the display brightness.
The available setting ranges differ depending on
[DIM SETTING].
Select the key color when a call is received.
Applies the color set by [KEY COLOR].
Cycle through a variety of colors automatically.
No change in key color made.
17
En