Unpacking Instruction; Power Supply; Remote Control Function; Front Panel - Fenton AV360BT Manuel D'instructions

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

REMOTE CONTROL FUNCTION

1. POWER ON/OFF
Turn the device ON or OFF.
2. MODE
Press to choose between USB/SD, BT and FM.
3. MUTE
By pressing this button, the device will be muted.
4. PLAY/PAUSE
Start/resume or pause play by pressing this button.
5. PREVIOUS/NEXT TRACK
Skip to previous or next track by pressing these buttons.
6. EQ
Press to choose EQ preset.
7. VOLUME UP/DOWN
Press to adjust the volume to the desired level.
8. USB OR SD
Choose between USB and SD input modes.
9. REPEAT
Press to repeat one song or complete folder.
10. NUMPAD
Use for choosing tracks directly.

FRONT PANEL

1. POWER BUTTON
Turn the device on or off.
2. TONE CONTROL
Using the bass and treble knobs, the overall
system frequency response can be adjusted.
3. VOLUME CONTROL
Turn to adjust the volume to the desired level.
4. INPUT
Press to switch input channel.
5. PREVIOUS TRACK
Skip to previous track.
6. NEXT TRACK
Skip to next track.
7. PLAY/PAUSE
Start or pause play by pressing this button.
8. USB PORT
USB entry port.
9. SD CARD SLOT
Insert an SD card in this slot.
4