Door Swing Reversal - Silhouette Select DBC162BLSST Manuel Du Propriétaire

Installation Instructions - Door Swing Reversal
Fig 1A
Fig 1C
Fig 1E
1 Bottom hinge (Right)
4 Screws
7 Decorative nail
Bottom hinge (Left)
10
1 When open the door 90 degree, take out 2 screws from lower door axis (3),
remove the door refer Fig. 1A, then pull out the door and door axis (Fig. 1A).
2 Put the door safety and take out decorative nail (7) from top of door frame,
unscrew 2 screws (4) at bottom and remove the Extrusion-board of lamp switch (5),
then install (5) at top of door frame, please use spare decorative nail to block
the hole at top of door frame. (Fig. 1A/1B)
3 Make out 3 screws (8) from top hinge (right) (6) and remove the right top
hinge. (Fig. 1C)
4 Remove decorative nail (10) from left top of cabinet and install spare top
hinge (Left) (9) at left top of cabinet with 3 screws. (Fig. 1D)
5 According above procedure, install spare lower hinge (left) (11) onto left
lower cabinet. (Fig. 1E)
6 The door revolves 180 degrees, install the door with same way it was removed
and fix it with door alightment.
7 Block the hole at right top of cabinet with spare decorative nail.
2 Screws
5 Extrusion-board of lamp swith
8 Screws
Decorative nail
11
9
Fig 1B
Fig 1D
3 Door axis
6 Top hinge (Right)
9 Top hinge (Left)