Dörr HS-800 Notice D'utilisation page 9

04 | FIRST STEPS
04.1 Charging the built-in Li-Ion battery
·
Before first use, please fully charge the built-in Li-Ion battery.
·
Only charge with the supplied USB charging cable
·
Never leave the light unattended while charging.
Fold the transparent cover (04) upwards. Insert the low-voltage plug (07a) of the USB charging cable (07) into the low-voltage socket
(05). Connect the USB-A plug (07b) to a USB socket on your computer. The charging process starts.
While charging, the battery charging and capacity indicator (06) flashes red. After approx. 3-4 hours the Li-Ion battery is fully charged
and the battery charge and capacity indicator (06) lights up constantly in red-green
Remove the USB charging cable and close the cover (4) properly to ensure the water resistance.
05 | FUNCTIONS OF THE LIGHT
05.1 Switching On/Off, adjusting the brightness, SOS flashing function
To switch on the light, press the On/Off button (02) once. The lamp shines with 50% brightness.
For 100% brightness, press the On/Off button (02) a second time shortly after switching on (within max. 5 seconds), for the SOS
flashing function press a third time and to switch off a fourth time.
Note: If the lamp is in a light mode for more than 5 seconds, the lamp can be switched off directly by pressing the On/Off
button (02) once.
05.2 Stand/Hanger
Unfold the stand/hanger (03) as shown below to place or to hang up the light:
9
.
doerr-outdoor.de