Panasonic CS-RE18PKE-3 Comment Utiliser L'appareil page 6

How to use
MODE
To select operation mode
AUTO mode - For your convenience
• During operation mode selection the power
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL mode - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
Auto OFF/ON button
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
• To use in AUTO mode, press the button once.
• To use in COOL mode, press and hold the button until 1 beep is heard, then release.
• To use in HEAT mode, press and hold the button until 1 beep is heard, then release.
And press again until 2 beeps, then release.
• Press the button again to turn off.
6
F568903_YA0712-0.indb 6 F568903_YA0712-0.indb 6
Remote control
display
AUTO FAN
SPEED
HEAT
COOL
DRY
AIR
SWING
OFF/ON OFF/ON
MODE
TEMP TEMP
AIR SWING
FAN SPEED
TIMER TIMER
ON ON SET SET
1 1 2 2 3 3
OFF OFF CANCEL CANCEL
AC
RC
SET CHECK CLOCK CHECK CLOCK RESET
FAN SPEED
To select fan speed
( )
Remote control display
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
Remote control receiver
and indicator
(Green)
POWER
(Orange)
TIMER
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
10/24/2012 1:51:58 PM 10/24/2012 1:51:58 PM