Dishwasher Won't Fill; Dishwasher Has An Odor; Removing Spots And Film - Electrolux 154671201 Guide D'utilisation Et D'entretien

DISHWASHER WON'T FILL

• Check to see if the water supply is
turned on.
• Add 1/2 cup of water to the bottom of the unit
off.
and start again.

DISHWASHER HAS AN ODOR

• Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.
• There will be a "new" smell when first
installed. This is normal.
• Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
21).
REMOVING SPOTS AND
FILM
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
19).
To remove build-up, spots and film, clean
using the following instructions:
1 Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2 Do not add detergent.
3 Select the NORMAL WASH cycle. Press
START/CANCEL pad and close door.
4 Allow dishwasher to run until it begins the
second fill. Open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
5 Close and latch door and allow cycle to
finish.
NOTE
If these conditions persist, a home water
softener should be considered.
Solutions to Common Problems
ERROR CODES
In certain situations which are critical to
machine function and safe operation.
Error codes will be shown in the status
window on the EIDW6305.
Er 01
Er 02
Er 03
Er 04
Er 05
Er 06
Er 07
Er 08
Er 09
Er 10
Er 11
Er 12
Er 13
Leak Detector - When water is detected under
the tub.
Thermistor - When thermistor/turbidity module
fails
Wash Pump - Wash pump not operating
Drying Damper - Drying damper not operating
Upper Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the upper fan
Lower Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the lower fan
Drain Valve - When in the drain mode, the control
board does not receive proper position feedback
from the drain valve
Tactile or touch switch - Control board has
verified a switch on the user interface is bad or
shorted
Communications - Communication failure be-
tween main user board and power supply
Mains Relay - Failure in the mains power relay
Drain Valve - Time out before finding a state for
the drain valve
Drain Valve - The drain valve is running when it
should be off
System wide - Lost control of the State Machine
21