Installation Procedures - Jofel AA17050 Manuel D'utilisation

Installation Procedures

I Use a single-phase alternating rated voltage supply. (Do not be used with a power supply exceeding rated voltage ±10%.)
I Use a power cord which is between 2 mm
(Adrop in voltage is possible if the power cord exceeds 11 m in length, so we recommend using a 2.5 mm
Wire the unit.
Embed the switchbox in the installation location
1
(1 switchbox no cover) and wire the power cord
(with the green and yellow combined is ground line).
• If no switchbox is used, the power cord will be
pushed out, and prevent the unit from being
installed firmiy against the wall.
Attach the installation panel to the wall using the
4 installation screws.
• If the wall is concrete, use commercially available
metal screw plugs (curi plugs, etc.).
2
• If the wall is not concrete, reinforce it before
installation.
• Paste the drilling stickers into the wall as picture,
drilling according to the holes.
• Put the expansion pipe into the hole, and fix
the mounting plate as picture.
1. Pull Out drain tank and Air Filter
• If plug supply electricity, follow step 6 and
step 7 directly.
• If wire supply electricity, first pull out the
electric cover and power cords.
3
Air filter
Pull the separate line power cord into the unit
PulI This machine has been with power cord, if you
want to change, please according to the following
steps.
• Elevate the unit with a height of about 250 mm pad
to, make the two junction (in unit & in wall) box with
4
the same height according to the following steps,
connect wire to terminal blocks of unit.
(1) Take off the insulating layer of the power line.
(2) Connect power line to terminal blocks of unit.
(3) Tighten the screws on the terminal box and pull
the powercord to make sure it is secured firmly.
(4) Fix the power line into the unit by the screw and
pressure line cover.
2
and 2.5 mm
drain tank
2
thick. (Cords other than 2 mm
drilling stickers
2. Pull out electric cover and power cords
(1) Unscrew the 2 screws on the electric cover,
open the cover.
(2) Unscrew the 2 screws on the pressure line
cover, loosen the 3 screws on terminal box,
then pull out the power wire.
Pad black
- 20 -
2 2
- 2.5 mm single-core cords cannot be used.)
2
cord.)
Power cords
(with ground line)
installation
panel
installation screws
switchbox
Safety screw hole
terminal box
Pressure
line cover
electric cover
Power cords
Power
cords
terminal box
Earth wire
Pressure
Line cover