Publicité
Les langues disponibles
Les langues disponibles
Installation
The installation must be carried out by a qualified specialist.
1. Drill two holes 6 mm in diameter 140 mm apart (see picture 2). Insert rawlplugs into the holes and
fix the hanger to the bottom hole with a screw. Then hang the bracket up and secure with a screw
in the top hole.
2. Remove front cover (3) (see picture 3).
3. Electrical connection:
Connection to the mains: attach the mains connection to the connector strip (1) and clamp it down
with a wire clamp (see picture 4).
When flush-mounted: open up the base as intended (2) and connect power supply (230/240V) to
the connector strip (1) (see picture 4).
4. Check the installation diagram and make sure the panel and front cover are secure.
5. Turn on power and master switch.
Pic. 2
1. Rawlplug
2. Screw
3. Cover panel
4. Hanger
5. Screw
Pic. 3
1. Transparent front cover
2. Panel
3. Front panel
4. Screw 2
5. Cover plate
Pic. 4
1. Clamp
2. Wire entry opening
3. Holder top section
How to use
Switch on the power and remove the dryer from the holder. The dryer will work when the power button
(9) is pushed in. Move heat setting button (10) up or down to alter the heat setting. If the unit is not
being used for a long period of time, switch off the master power switch to disconnect it from the mains.
How to use the electric razor outlets
Lift up the transparent front cover. The electric razor outlets can only be used if the main power switch
is switched on. Pull down the panel in order to turn off the power if the outlet is not being used.
955-21_ComfortLinePlus-Betriebsanleitung.indd 15
1
2
3
4
5
Pic. 2
1
2
3
4
5
Pic. 3
1
2
3
Pic. 4
15
07.08.14 13:45
Publicité
