Crunch G PX2200.1D Mode D'emploi page 11

FIGURES
(P. 28-31)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1a) Mono audio input (OUT), leading to an additional GPX2200.1D
(1b) Mono audio input (LINE INPUT), coming from an additional GPX2200.1D
(2) Stereo audio input, coming from the headunit
(3) Gain level controller
(4) Bass Boost controller
(5) Lowpass filter controller
(6) Subsonic filter controller
(7) Phase Shift controller
(8) Remote jack for the included bass remote control
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REMOTE terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) In-Line Fuse 50 A ANL (not included in the scope of delivery and required)
(6) Turn on wire from the headunit or the electrical antenna
(7) Fuse
(8) Power-/Protection-LED
1-CHANNEL MONO OPERATION STEREO (FIG. 3) WITH 1 SUBWOOFER
If you want to run the amplifier with the 2 line output channels from the headunit to drive 1 subwoofer,
connect the following setup:
(1) To the headunit, line output left
(2) To the headunit, line output right
(3) Subwoofer (1-8 Ohms)
(4) Bass remote control to adjust the bass level out of the driver's seat
1-CHANNEL MONO OPERATION STEREO (FIG. 4) WITH 2 SUBWOOFERS
If you want to run the amplifier with the 2 line output channels from the headunit to drive 2 subwoofers,
connect the following setup:
(1) To the headunit, line output left
(2) To the headunit, line output right
(3) Subwoofer 1 (2-8 Ohms)
(4) Subwoofer 2 (2-8 Ohms)
(5) Bass remote control to adjust the bass level out of the driver's seat
ENG
11