Operation - Vitalmaxx TL3201 Mode D'emploi

Unpack all parts and make sure that the scope of delivery is
complete (see chapter "Device overview and scope of delive-
ry") and check for any damages from transport. If applicable,
remove any stickers and foils. If the device is damaged, do not
use it (!), instead contact customer service.

Operation

ATTENTION!
■ Do not use the device on wet hair. Your hair must at least
be towel-dried!
■ Check the device for damages prior to each use. The de-
vice may not be used if it, the mains cord or plug exhibit
visible damages. Do not use the device if it malfunctions,
has fallen down or in water.
■ The brush becomes hot during use. Be careful when hand-
ling the brush and only hold the device by the handle. Keep
the brush away from your face, especially your eyes. Also
keep a safe distance of at least 3 – 5 cm between your
head and the brush.
Start-up
1. Connect the device to a properly installed socket that cor-
responds to the device's technical data.
2. Select a temperature setting with the On/Off switch:
– I (low temperature setting; approx. 150
light is illuminated in green.
– II (high temperature setting; approx. 200 °C). The control
light is illuminated in red.
3. Set the On/Off switch to the 0 position if you would like to
turn the device off. The control light will turn off. Always pull
21 EN
°C). The control