Installation & Operation; Icm Placement Instructions - FRIGOGLASS EasyPick Mode D'emploi

3 Installation & operation

3.1 ICM placement instructions

ICM must be lifted only as indicated in the image below when unloading from pallet and in any other
case thereafter.
Failure to comply with the instructions may result in high-energy
consumption, poor performance of the unit and void warranty.
Keep clear of obstruction all ventilation openings in the
appliance enclosure or in the structure for building-in
Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the
manufacturer
Do not damage the refrigerant circuit
Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Do not place the merchandiser:
in direct sunlight or near heat sources (radiators, stoves & other
heating equipment)
outdoors (outdoor placement is prohibited)
in climate conditions for which it is not certified
in extreme environmental conditions (i.e. extensive exposure to
saline humidity)
on a surface with an angle more than 5
o
ENG
9