Heat Controller Comfort-Aire Série Manuel De L'utilisateur page 15

PROCEDURE B
6
Remove the backing from the support blocks
and attach them to the inside of the wall sleeve
as shown FIG 13. Slide the baffle into slots of
the support blocks.
Wall
Wall
Sleeve
Front
7
Install the new unit into the wall sleeve.
Assemble trim as described in Step 5,
8
Procedure A.
CAUTION
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and rear
coils.
• Make sure air conditioner does not fall during
removal.
• If unit does not operate after installation check, to be
sure the circuit interrupter has not been tripped.
Refer to the Troubleshooting guide for reset
procedure.
( )
7 3 / "
32
Baffle
Support
Block
FIG. 13
Installation
Owner's Manual 15