Nikken PiMag MICROJET SHOWER Manuel D'installation Et D'utilisation page 4

6. Wrap plumbing tape to the connector on the
bottom of the MicroJet hand unit (H). Keep the
tape surface flat and wrap in a clockwise
direction. Insert a rubber washer (C) in the end
of the MicroJet flexible hose that has the round
(smooth) nut (I). Attach this end of the flexible
hose to the MicroJet hand unit (H). Caution: do
not overtighten.
7. Insert the hose into the bracket hose retainer (J)
with the hand unit (H) pointing upward to hold
the assembled MicroJet Hand Shower in place.
Wall-mounted model
1. Remove any showerhead that is already
installed.
2. Take the MicroJet unit out of its packaging and
remove any protective plastic or covers.
3. Wrap plumbing tape around the screw threads
of your plumbing pipe. Keep the tape surface flat
and wrap in a clockwise direction.
4. Attach MicroJet shower unit to plumbing pipe.