Publicité
Les langues disponibles
Les langues disponibles
Depending on the smartphone model and its Android OS
version, the process of the NFC activation may be
different. Refer to the smartphone manual for more details.
Turn on the One Touch button on the User Interface by
pressing 2 seconds to enable the NFC antenna on the Sky Led.
The One Touch label switches on.
Open the App, create the user profile and register the appliance
following the instructions on the phone display or the "Quick
Guide" attached on the machine.
More information, F.A.Q. and the video for an easy
registration are available on:
www.hooveronetouch.com/how-to
NEXT TIME – Regular usage
Every time you want to manage the machine through the App,
first you have to enable the One Touch mode by turning on the
One Touch button.
Make sure you have unlocked your phone (from stand-by mode)
and you have activated the NFC function; then, follow the steps
mentioned earlier.
If you want to activate a function (e.g. Super Boost cycle),
select it in the App.
Follow the instructions on the phone display, KEEPING IT ON
the One Touch logo on the Sky Led, when requested to do so
by the App.
NOTES:
Place your smartphone so that the NFC antenna on its
back matches the position of the One Touch logo on
the appliance (as illustrated below).
If you do not know the position of your NFC antenna,
slightly move the smartphone in a circular motion over the
One Touch logo until the App confirms the connection. In
order for the data transfer to be successful, it is essential
TO KEEP THE SMARTPHONE ON THE DASHBOARD
DURING THESE THE FEW SECONDS OF THE PROCEDURE;
a message on the device will inform about the correct
outcome of the operation and advise you when it is
possible to move the smartphone away.
Thick cases or metallic stickers on your smartphone
could affect or prevent the transmission of data between
machine and telephone. If necessary, remove them.
The replacement of some components of the smartphone (e.g.
back cover, battery, etc...) with non-original ones, could result in
the NFC antenna removal, preventing the full use of the App.
The management and the control of the machine via App is only
possible "by proximity": it is therefore not possible to perform
remote operations (e.g.: from another room; outside of the
house).
User interface
1.
Setting Panel:
A
This version doesn't any setting on interface to switch on
or switch off the appliance. The only way to switch on/ off
9
the appliance is by plug in / off.
2. SETTING BUTTON C
Press this button to set running temperature of fridge
and choose super mode.
3. DISPLAYS OPERATION
A)
Super Freezing:
freezing. Reversely, supper freezing is off.
B) Setting Temperature of Fridge compartment. The
number under which LED is on is the setting
temperature.
4. OPERATING CONDITION
After power on, all LED lights on panel are lit up for 1
EN23
C
B
LED's on means starting supper
10
Publicité
