Use - Hydas Hydrofit Mode D'emploi

the bath tub and outside the marked area
(Fig. 1). The distance from the fl oor must
be at least 30 cm (Fig. 2). The air inlet on
the underside must not be covered. Do not
use any foaming bath additives ("bubble-
bath") when bathing with this appliance!

Use

Make sure the room temperature is right. Tip: let the fan warm up for
approx. 5 minutes; this avoids a cooling effect on the skin due to the
jet bubbles.
1. put the softmat in the tub and press down on it fi rmly. (Fig.3) So that
the suckers on the base of the air spray mat stick better, rinse down
the mat a little before laying it in
the tub. Make sure that the mat is
lying fi rmly on the base and does
not slip.
Note: To take the mat out of the bath
after use without any damage, prise
the sucker away with fingernails. Then
gently pull the side of the mat away
from the bottom of the bath.
2. Attach hose to the soft mat with
the connector (Fig. 3)
3. Connect the hose to the appliance
(1.1) with the appliance adaptor
(2.2) and rotate to secure it (Fig. 4).
4. Let in the bath water at the right
Fig. 1
Fig. 2
Fig. 3
Fig. 4
15