Danby Designer DDW1802W Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BEFORE CALLING FOR SERVICE . . .
Problem
Glassware is
cloudy
Yellow or brown film
on inside surfaces
White film on inside
surface
Detergent left in
dispenser cups
Steam
Black or gray
marks on dishes
Water standing in
the bottom of the tub
Water doesn t pump
out of the tub
Dishwasher leaks
11
Possible Causes
Combination of soft
water and too much
detergent
Tea or coffee stains
Iron deposits in water
can cause an overall film
Hard water minerals
Dishes block detergent
cups
Normal phenomenon
Aluminum utensils have
rubbed against dishes
This is normal
'
Drain is clogged
Overfill dispenser or rinse
aid spills
'
Dishwasher isn t level
What To Do
Use less detergent if you have soft water and select a
shortest cycle to wash the glassware and to get them clean.
Using a solution of 1/2 cup of bleach and 3 cups warm water
to remove the stains by hand.
WARNING
You have to wait for 20 minutes after a cycle to let the heating
elements cool down before cleaning the interior; otherwise,
burns will happen.
Call a water softener company for a special filter.
To clean the interior, use a damp sponge with dishwasher
detergent and wear rubber gloves. Never use any other cleaner
than dishwasher detergent for the risk of foaming or suds.
Re-loading the dishes properly.
There is some steam coming through the vent by the door
latch during drying and water draining.
Use a mild abrasive cleaner to eliminate marks.
A small amount of clean water around the outlet on
the tub bottom at the back of the tub keeps the water
seal lubricated.
Make sure the kitchen sink is draining well.
If the dishwasher drains into a disposer, run it clear.
Be careful not to overfill the rinse aid dispenser.
Spilled rinse aid could cause oversudsing and lead
to overflowing. Wipe away any spills with a damp cloth.
Make sure the dishwasher is level.

Publicité

Chapitres

Table des Matières
loading

Table des Matières